Thermoworks makes great hardware, but terrible software. Periodically, I would ask them why the temperature plots of data from their wireless thermometers have to look like this:

They would tell me that the app can’t get data from the temperature probe while the phone screen is off. It made it hard to estimate the remaining cooking time without leaving my phone screen open the whole time, but I’m not a software developer, so what could I do?
I would ask why plots sometimes look like this:

It’s hard to tell if the temperature reading is just noisy or if something’s going on, but I’m pretty sure the internal temperature of a brisket doesn’t jump up and down several degrees in a span of a minute or two. I would ask if it would be possible to get just a dot plot of the data, without a line connecting the points. They would persist to such an extent in failing to understand the request, across multiple support threads and representatives, that I suspected I was part of some postmodern “Who’s on first?” routine. Sometimes they would tell me to use the webpage of their cloud service instead of the app.
One rainy night, when I was smoking a brisket and annoyed by gaps in the plot, I thought of checking back in with them to see if they were planning any updates. I found the last thread, re-read it, and thought, “I hear Claude is pretty good at reverse engineering. I wonder if it can just grab the data over Bluetooth, I can make my own damn plot, and I can keep stuff out of someone else’s cloud, too?”
About 30 minutes later…

Thermoworks, if you’re reading this, you may want to ask your app developers to request a wakelock. I don’t know exactly what that is, or if that’s the solution, but it is in fact possible to grab data while the screen is off. Hope this helps someone.